If these are the valves with the ball bearings make sure you don't mix the
balls up. They are
different sizes.
Mark
----- Original Message -----
From: "Kenny J" <theswed@hotmail.com>
To: "Healeys Healeys" <healeys@autox.team.net>
Sent: Monday, September 15, 2008 1:44 PM
Subject: [Healeys] More OD issues
>I finally got the OD unit onto the gearbox and installed over the weekend.
>I
> took the car for a test drive and the OD unit would not engage. The
> solenoid
> worked fine. Therefore, I figured there was a hydraulic issue. I got a
> hold
> of a service manual and decided to pull off the solenoid bracket and take
> out
> the pump valve. I also took out the one on the right side of the OD unit.
> After cleaning and re-installing valves, I looked inside and noticed when
> I
> would turn the driveshaft the pump spring would not compress. I figured
> the
> pump may not be contacting the oil cam on the mainshaft and is not working
> properly. Am I right thinking this? Can the pump possibly be stuck? Any
> suggestions?
>
> Kenny
> 61 BT7
> _________________________________________________________________
> See how Windows connects the people, information, and fun that are part of
> your life.
> http://clk.atdmt.com/MRT/go/msnnkwxp1020093175mrt/direct/01/
> _______________________________________________
> Support Team.Net http://www.team.net/donate.html
>
> Healeys@autox.team.net
> http://autox.team.net/mailman/listinfo/healeys
>
> You are subscribed as lapierrem@sbcglobal.net
>
> http://www.team.net/archive
_______________________________________________
Support Team.Net http://www.team.net/donate.html
Healeys@autox.team.net
http://autox.team.net/mailman/listinfo/healeys
http://www.team.net/archive
|