healeys
[Top] [All Lists]

Re: [Healeys] hydrolic and battery cable sources

To: John Snyder <helyjohn@cablespeed.com>, stella67@aol.com, Healey Mail
Subject: Re: [Healeys] hydrolic and battery cable sources
From: David Schweninger <quenty@ntelos.net>
Date: Sat, 13 Sep 2008 14:34:55 -0400
Hi guys.
Doug Reid (Mr. Finespanner) Can be reached at:  301 898 8881 or 
mailto:mrfinespanner@earthlink.net

He does beautiful work.
Dave and Daisy

On Sep 13, 2008, at 1:03 PM, John Snyder wrote:

> Contact Doug Reid for correct, pre-formed brake and fuel lines.  The  
> last
> email address I have for him is spannerman@earthlink.net .  Also,
> spannerman@prodigy.net  might work.
>
> John Snyder
>
> ----- Original Message -----
> From: <stella67@aol.com>
> To: <healeys@autox.team.net>
> Sent: Saturday, September 13, 2008 9:40 AM
> Subject: [Healeys] hydrolic and battery cable sources
>
>
>> I am restoring a BN7 MK II and starting to assemble some of the  
>> critical
>> parts? The body and frame are finally about ready, the engine and  
>> trans are
>> done and the reassembly will start soon.? In looking through the  
>> parts I
>> stored over the last seven years.? Having restored five Healeys I  
>> should
>> have known better but I did not keep track of my parts well.?Over  
>> the years
>> I have misplaced some critical parts. I can not find the battery  
>> cables for
>> the BN7 and the brake/ petrol lines.? This means I have none of the
>> original connectors or patterns for them. Since I am putting this  
>> together
>> "as original" I need a source of lines or the fittings and patterns  
>> of the
>> pieces needed.?I searched the archives but did not find?a source.?  
>> I may
>> have missed it because there was a?lot of information on hydraulics  
>> and
>> batteries. ?I would appreciate information on a source for the  
>> lines or the
>> parts to make the lines.?The last time I ordered?new hydraulic? 
>> lines the
>> came as rolled up copper lines
>> which is not what I want. I ordered some "original battery" cables  
>> and
>> they are incomplete and no where near correct.? I contacted British  
>> Wiring
>> and they don't make them?but will provide the parts - but without a? 
>> good
>> pattern that won't work.? Any suggestions - I know don't?toss parts  
>> before
>> you know what your are doing - would be appreciated.????Thanks John
> _______________________________________________
> Support Team.Net http://www.team.net/donate.html
>
> Healeys@autox.team.net
> http://autox.team.net/mailman/listinfo/healeys
>
> You are subscribed as quenty@ntelos.net
>
> http://www.team.net/archive
_______________________________________________
Support Team.Net http://www.team.net/donate.html

Healeys@autox.team.net
http://autox.team.net/mailman/listinfo/healeys


http://www.team.net/archive

<Prev in Thread] Current Thread [Next in Thread>