.
On Sep 2, 2008, at 5:52 PM, WILLIAM B LAWRENCE wrote:
> Start the nuts on the long set pins and pull them down gradually
> and evenly.
> If you encounter any resistance stop and check that the thrust
> washers haven't
> shifted. Better to lose a little time than break the washers. Some
> of them are
> getting hard to find. When the long pins bottom install the other
> fasteners.
DO NOT DO THIS !!!!!!!!!!!!!
You should pull the overdrive together with two large channel lock
pliers. If you can not pull it together by hand there is a miss
alignment in side. I have sold many adaptor plates the people broke
pull the overdrive together with the two long studs and nuts.
David Nock
British Car Specialists
Stockton Ca 95205
209-948-8767
www.britishcarspecialists.com
.
_______________________________________________
Support Team.Net http://www.team.net/donate.html
Healeys@autox.team.net
http://autox.team.net/mailman/listinfo/healeys
http://www.team.net/archive
|