Steve -
These are fixed with brass nuts and the gaskets seal best with light
pressure. I don't know if there's a torque setting for these but
usually around 25 ft lbs should do the job. Too tight and you'll
pinch the gaskets which makes them not seal properly.
Alan
On 7/24/08, Steve Thomton <scthomton@yahoo.com> wrote:
> Can anyone help with the torque settings for the exhaust and intake
> manifolds? I'm concerned that I may have over tightened the brass nuts on
> the
> exhaust......I can't find a spec for them in the AH shop manual.
>
> Thanks,
> Steve Thomton
> Larkpsur, CO
> _______________________________________________
> Support Team.Net http://www.team.net/donate.html
>
> Healeys@autox.team.net
> http://autox.team.net/mailman/listinfo/healeys
>
> You are subscribed as healey.nut@gmail.com
>
> http://www.team.net/archive
>
--
Sent from Gmail for mobile | mobile.google.com
Alan
'52 A90
'53 BN1
'64 BJ8
_______________________________________________
Support Team.Net http://www.team.net/donate.html
Healeys@autox.team.net
http://autox.team.net/mailman/listinfo/healeys
http://www.team.net/archive
|