My tach quit about a few months ago. I noted that the cable at that time was
still spinning so I sent the tach to MOMA for repair. She did not note
anything wrong, but cleaned it. I put it back in and it quit again in two
weeks but this time the cable broke. I put in a new cable and it was making
some noise on the way to the Chico car show so I put my hand back there to
adjust the bends in the cable. The entry point to the tach was very hot, so I
disconnected the cable. Are the MOSS supplied cables a little long at the
tips? Perhaps that extra length is causing too much friction?
Jerry
BN4
_______________________________________________
Support Team.Net http://www.team.net/donate.html
Healeys@autox.team.net
http://autox.team.net/mailman/listinfo/healeys
http://www.team.net/archive
|