I did mine with a deep socket.
However, be warned, each side of the "nipple" has a rubber gasket that stops
the leaking.....you will destroy this gasket when you take the "nipple" off.
They must be replaced with a brake fluid resistant material. I made mine
with some old tire tube....but took me a few times to get it right.
Paul
-----Original Message-----
From: healeys-bounces+bj8mk3=shaw.ca@autox.team.net
[mailto:healeys-bounces+bj8mk3=shaw.ca@autox.team.net] On Behalf Of Freese,
Ken
Sent: Thursday, December 20, 2007 7:22 AM
To: healeys@autox.team.net
Subject: [Healeys] 3000 brake fluid resevoir
Any tips on taking the nipples out of the can so that I can clean and
repaint? The nipple in the center tube is turning and I don't have
sockets that fit down the tube.
Ken Freese
65 BJ8
Healeys@autox.team.net
http://autox.team.net/mailman/listinfo/healeys
_______________________________________________
Support Team.Net http://www.team.net/donate.html
Healeys@autox.team.net
http://autox.team.net/mailman/listinfo/healeys
|