G'day
I had all my brake and clutch cylinders rebuilt by resleeving with
stainless steel sleeves. In a Mk2 Jaguar I used to have I did the same.
Not a problem since.
Hoo Roo
Patrick Quinn
Sydney, Australia
1947 Healey Duncan Saloon
1954 Austin-Healey 100 BN3/1
-----Original Message-----
From: healeys-bounces@autox.team.net
[mailto:healeys-bounces@autox.team.net] On Behalf Of WILLIAM B LAWRENCE
Sent: Thursday, 5 July 2007 9:09 AM
To: caddi5@comcast.net; healeys@autox.team.net
Subject: Re: [Healeys] clutch slave cylinder
>From my experience the alloy cylinders (master and slave) are easily
rebuildable.
I have never found one that showed any pitting or wear. Some of them did
have a coating of a shellac like material that I theorize was the
remains of
old brake fluid that had dried out and hardened.
The main thing to remember is that the bores of these cylinders are
coated
with an anodized layer that should not be disturbed as would occur by
honing. This layer is pretty much impervious to corrosion unless it is
exposed to an electrolytic force like a salt water bath...
I wouldn't try to rebuild a cylinder with a bore that showed damage of
any
kind because they would require honing, but you may need to clean the
bore
to discover if it is damaged.
I cleaned mine up in the kitchen sink with hot water, dish soap and an
old
tooth brush. For the tougher spots a little soft scrub did the job.
After washing the cylinders I rinsed them thorougly and put them in the
oven
at about 250 degrees for a half hour or so to dry them out.
(It's usually best to do these things when the wife is out of the house,
Just don't forget to clean up.)
A little attention to detail during assembly and they should be as good
as
new. I like this method because it doesn't use any petroleum based
cleaners
which might leave residuals that are difficult to clean out of the
braking
system, it results in a clean, like new part and my hands were clean and
silky smooth. That doesn't happen much in this hobby.
Bill Lawrence
BN1
>From: caddi5@comcast.net
>To: healeys@autox.team.net Subject: [Healeys] clutch slave cylinder
>Date: Wed, 04 Jul 2007 13:49:34 +0000
>
>Happy 4th,
>Should I rebuild or just replace my clutch slave and master cylinder?
who
>should I buy the new units or rebuild kits from? is it a very tricky
oper.
>to rebuild these units? i just don't want to make a major ordeal out of
>this I've got too many other things to do...thanks Mitch 1959 bn4
**********************************************************************
This message is intended for the addressee named and may contain
privileged information or confidential information or both. If you
are not the intended recipient please delete it and notify the sender.
**********************************************************************
_______________________________________________
Healeys@autox.team.net
http://autox.team.net/mailman/listinfo/healeys
|