Contact cement has been doing the job for me for several years, although I
did use the 1/4" thick foil-faced bubble wrap from the home improvement
store. I also think I put in a pop rivet or two with a washer under the
head to make sure the insulation on the underside doesn't come loose in the
heat and end up in the universal joint.
Steve Byers
HBJ8L/36666
BJ8 Registry
Havelock, NC USA
-----Original Message-----
From: owner-healeys@Autox.Team.Net
[mailto:owner-healeys@Autox.Team.Net]On Behalf Of Ronald J. Ray
Sent: Monday, February 12, 2007 11:30 AM
To: Patton Dickson
Cc: Dan Serrao; healeys@autox.team.net
Subject: RE: Transmission Tunnel
Patton,
The material is foiled faced on both sides.
I used double-backed tape to hold it in place.
Ron Ray
-----Original Message-----
From: Patton Dickson [mailto:57healey@gmail.com]
Sent: Monday, February 12, 2007 1:23 PM
To: Ronald J. Ray
Cc: Dan Serrao; healeys@autox.team.net
Subject: Re: Transmission Tunnel
Ron,
Is this sticky sided stuff or did you have to glue this down?
Patton
On 2/11/07, Ronald J. Ray <ronald-ray@sbcglobal.net> wrote:
Dan,
I used a foiled faced bubble product specifically manufactured for the
automotive industry called BA820 and manufactured by Reflectic Inc.
(800-879-3645 Jerry Saunders.) This product utilizes thicker aluminum
facers and a thicker core material than what can be found at home
improvement centers. As always, no financial or other connections with
the
manufacturer.
Ron Ray
--
Patton Dickson - http://Austin-Healeys.com
1957 Austin-Healey 100-Six "Built to run 'til the road wears out."
|