Would like to confirm this install setup from someone who has the same
setup:
Am currently using the following setup with points. Polarity checks out
using the "Pencil-in-the-spark" method:
Black/White distributor wire to Neg terminal on coil (trunk switch not
attached)
Double white wire from ign. switch to Pos terminal on coil.
Pertronix' instructions do not say which way the above wiring is to be
hooked up, but say the following:
Black wire to Neg coil terminal
Red wire to Pos coil terminal
Would like to confirm this is the way to hook up the Pertronix with my
wiring as above on the coil. Don't wanna fry the dang little bugger!
Thanks in advance.
--
Steve Gerow
Pasadena CA
59 BN6
|