Rich, Excellent! Thank you.
Lin Rose
On Sep 3, 2006, at 10:55 PM, Rich C wrote:
> Hi Lin,
>
> Whew, I found it!
> I have an old original block saved from when I had my tricarb BT7.
> These blocks are exactly 1 5/8" by 1 1/4" by 15/16" thick. They are
> counter bored right through the middle to take the sheet metal
> fixing screw. The 1 5/8" size goes across the width of the car as
> per this picture.
>
> Rich Chrysler
>
> ----- Original Message ----- From: "linwood rose"
> <linwoodrose@mac.com>
> To: "list healey" <healeys@autox.team.net>
> Sent: Sunday, September 03, 2006 2:09 PM
> Subject: wood block - door seal cap
>
>
>> Can anyone give me the dimensions (all three) of the two little
>> vinyl covered wooden blocks that fit under the aluminum door seal
>> caps on a BT7? I am talking about the piece that the furlex/rubber
>> seal secures to at its conclusion toward the rear of the car.
>>
>> Thanks very much.
>>
>> Lin Rose
>> 1960 BT7 in restoration
>> 1959 Bugeye
[demime 1.01d removed an attachment of type image/jpeg which had a name of 3000
Rdstr Detail 0014.jpg]
|