Some of the other things that you should do while installing a new
clutch
Transmission seals front and rear
Shifter seal on top shift trans
Rear crank seal kit on all 6 cylinder cars
New slave cylinder and hose
Transmission mounts
Change oil in transmission
Check hand brake bracket on frame the commonly break
Performance upgrades I would install a lightened flywheel
David Nock
British Car Specialists
Stockton Ca 95205
209-948-8767
www.britishcarspecialists.com
.
.
On Aug 21, 2006, at 9:11 AM, Freese, Ken wrote:
> Burt,
> I have done it in a day. Yes, you need some floor jacks. A strong
> helper
> is strongly encouraged also. While you are in there, replace the
> clutch
> hose. While you are in there, do the throttle cross shaft bushings.
> While you are in there, do the transmission tie rod bushings. While
> you
> are in there, check the drive shaft U-joints. While you are in there,
> fit new seals to the tunnel cover.
> There is a strong possibility these other tasks will increase the
> length
> of the job from a day to a week.
> Ken Freese
> 65 BJ8
|