Best thing about Hylomar is the fact that it stays soft and will allow
parts to separate cleanly when disassembling again. Valve adjusting
comes to mind. I've reused gaskets a couple times when Hylomar was involved.
Dave
skip wrote:
> I like Hylomar... easy to apply, easy to clean up, and it works almost
> everywhere for everything.... (Only place I haven't used it is on very
> high temp parts (i.e. I don't use it for the exhaust manifold, nor
> muffler).
>
> -skip-
>
> Ned Smith wrote:
>
>> All the parts are in and I will start to reassemble the engine and
>> transmission tomorrow.
>>
>> What is the feeling on the use of sealers? What type and where?
|