I finally have a technical question. I have a leak in my front HD8 and gas
comes from the bottom of the carburetor. I have taken off the float cover
to see if the needle valve is defective and it is fine. The gas was drained
out of the bowl. I checked for loose screws on the bottom of the carb, but
they were tight. I am out of town, and will not be back until late Friday
night. I am planning to remove both carburetors and rebuild them. Should I
purchase a full rebuild kit or only the gasket kit and who should I get them
from, as the prices vary greatly.
Thanks,
Mark Goodman
|