I made up a wrench using a short piece of scrap square tubing of about
the same size as the plug, and notched four 'teeth' in it, hand filed
and tweaked to fit four of the slots. Added another long piece of
smaller sized scrap square tubing for a wrench handle and MIG welded
the pieces together. The result is so ugly that no one will ever take
it from my garage, but it worked fine for our BJ7.
-Roland
BN1
On Sun, 1 Jan 2006 07:35:28 -0800, you wrote:
::I found some of these type of slotted drive sockets at Kragen Auto Supply
::(in the U.S.). They had a variety of large diameter sizes. Not sure if they
::have the right correct size.
|