healeys
[Top] [All Lists]

Re: Checking Camber measurement

To: Healeys <healeys@autox.team.net>
Subject: Re: Checking Camber measurement
From: "Steve B. Gerow" <steveg@abrazosdata.com>
Date: Fri, 09 Dec 2005 19:50:59 -0800
Chris,
The hubs are perfectly true and only a couple of years old--the ends were
turned on a lathe as part of the manufacturing process and there's nothing
rough about them. I didn't see anything move when I was hammering off the
knockoffs.

At some point, I'm going to put the car in the street where I can push it
back and forth and repeat the process.
Steve


> From: "Chris Masucci"
> 
> Are you sure that the rough machined end of the hub is perpendicular to the
> wheels, that they are all the same and nothing moved even a little removing
> the knockoffs?
> 
> Cheers,
> Chris
> BJ8




<Prev in Thread] Current Thread [Next in Thread>