Hi Don,
The shoulder nuts may solve one problem, but how about the other. The
pump is threaded differently than the brass water valve that is supposed
to screw into it. In fact, my "new" pump, as it came, has a plain nipple
screwed into this hole with a different thread than the shutoff valve
thread. You can't just remove the nipple & screw the valve in. What is
your solution to this part of the problem?
Regards,
Dave Russell
BN2
Drtrite@aol.com wrote:
> In a message dated 7/4/05 10:59:26 AM Pacific Daylight Time,
> jleblanc@midsouth.rr.com writes:
> the casting and
> machining prevent tightening all 3 nuts that hold the pump to the block.
> There are two shoulder nuts that are used so you can get a wrench on the nuts.
>
> Don
|