| To: | <RonFineEsq@earthlink.net> |
|---|---|
| Subject: | Sealing Steering Box |
| From: | "Sam Marble" <samncyna@comcast.net> |
| Date: | Mon, 14 Feb 2005 18:52:54 -0500 |
Ron: I had a similar problem and the advice I got was to take the end plate off, clean all the shims carefully and then spray each of them with Permatex aerosol copper gasket seal on both sides. Then reassemble them in the same order with a new paper seal. Sam |
| <Prev in Thread] | Current Thread | [Next in Thread> |
|---|---|---|
| ||
| Previous by Date: | Re: BJ-8 Steering Wheel Replacement, Bluechipracing |
|---|---|
| Next by Date: | Car Inspection Service Warning, Bob, Kim, Rob, Bandit and Pepper |
| Previous by Thread: | Re: Sealing steering box, KENNETH MASON |
| Next by Thread: | Brake pad site, Simon Lachlan |
| Indexes: | [Date] [Thread] [Top] [All Lists] |