healeys
[Top] [All Lists]

Re: BJ-8 Steering Wheel Replacement

To: "BJ8Healeys" <sbyers@ec.rr.com>, "Healeys" <healeys@autox.team.net>
Subject: Re: BJ-8 Steering Wheel Replacement
From: "Bluechipracing" <bluechipracing@snet.net>
Date: Mon, 14 Feb 2005 18:11:46 -0500
   For smaller replacements see http://www.pbase.com/mdlempert/wheels

Jim


----- Original Message ----- 
From: "BJ8Healeys" <sbyers@ec.rr.com>
To: "Healeys" <healeys@autox.team.net>
Sent: Monday, February 14, 2005 5:27 PM
Subject: Re: BJ-8 Steering Wheel Replacement


> Hi, Ted -
>
> 1. Disconnect the steering column wiring harness in front of the steering 
> box.
> Tape the wires together tightly at the ends, with a string inside.  You 
> will
> pull this string into the steering column as you remove the harness, so 
> that
> you will have something to guide the harness back down the column on
> reinstallation.
> 2.  Remove the three setscrews (English:  grubscrews) that are equally 
> spaced
> around the steering wheel hub, just in front of the banjo wires.
> 3.  Pull the entire horn/turn signal unit out of the steering column, with 
> the
> harness wires trailing behind and pulling the string into the column. 
> When
> the harness clears the steering column inside the car, untape the harness 
> and
> string.  Remove the harness, leaving the string in the column.
> 4.  As you sit in the driver's seat, turn the big ridged locking nut 
> between
> the steering wheel and column clockwise to loosen it.  It may be difficult 
> to
> turn by hand.  I use a strap wrench and pad the nut with a cloth.  Loosen 
> it
> fully.
> 5.  Push the steering wheel in (i.e., toward the column).  The wheel is
> splined to the column and should slide, but may be difficult if the grease 
> is
> dried out.
> 6.  This will expose a snapring at the end of the column.  Remove this
> snapring and the steering wheel will come off.
>
> Someone else will have to recommend a smaller replacement.
>
> Steve Byers
> HBJ8L/36666
> BJ8 Registry
> Havelock, NC  USA
>
>  ----- Original Message -----
>  From: Broc07940@netscape.net
>  To: healeys@autox.team.net
>  Sent: Monday, February 14, 2005 3:19 PM
>  Subject: BJ-8 Steering Wheel Replacement
>
>
>  Can someone walk me through the steps in removing the steering wheel? 
> Also,
> any suggestions regarding a smaller diametered replacement?
>
>  Thanks,
>  Ted
>
>  __________________________________________________________________




<Prev in Thread] Current Thread [Next in Thread>