Paul,
Your description was very clear.
I have an early Hundred here in the shop and that dimension is 14 3/4", so
there is some slight variance from car to car compared to what Steve just
sent you. I think you'll find that once everything has carpet applied
including the lift away bulkhead panel having the carpet wrapping all the
way around onto the back side on the left and right sides, plus across the
stepped lip on the top that things will come together alright. That is why
bare metal panels by themselves do appear a bit short.
Rich Chrysler
----- Original Message -----
From: <Fiat500f@aol.com>
To: <healeys@autox.team.net>
Sent: Monday, January 31, 2005 12:07 AM
Subject: 100-4 measurement needed please...
> Ok all you folks with 100-4's, get out your tape measures! I think the
> guy
> who did a bit of welding on my friends 100-4 blew it, but I need a
> measurement
> to confirm this.
> OK, orientation first:
> If you are sitting in the drivers seat (USA spec. LHD) and you look down
> at
> your feet, you will have the inner sill panel next to your left foot and
> what
> I'll call the "kick panel" next to your right foot. I need the
> measurement
> from the inner sill to the kick panel. More clearly, the measurement from
> the
> inner sill to the rear most point of the kick panel (where that vertical ,
> removeable panel at the front of the gearbox cover screws on).
> The vertical panel on my friends 100-4 is the correct width, but it falls
> between the driverside kick panel and the passenger side kick panel. We
> think
> the welder welded the kick panels too far out, like, in the description
> above,
> too close to your right foot. Am I being clear enough? Ask questions if
> I'm
> not!
> Thanks (again)
> Paul Barnes
|