In the dark and with the carpet in the way that measurement appears to be
about 14.5 inches and is the width of the floorboard under the driver's
feet. If the vertical panel you are talking about is the closer above the
transmission aperture then I have a theory that they were trying to save
pennies when they made them. I had two of them and they both seemed too
small on a car that had never had those panels removed.
Bill Lawrence
On 1/30/05 10:07 PM, "Fiat500f@aol.com" <Fiat500f@aol.com> wrote:
> Ok all you folks with 100-4's, get out your tape measures! I think the guy
> who did a bit of welding on my friends 100-4 blew it, but I need a measurement
> to confirm this.
> OK, orientation first:
> If you are sitting in the drivers seat (USA spec. LHD) and you look down at
> your feet, you will have the inner sill panel next to your left foot and what
> I'll call the "kick panel" next to your right foot. I need the measurement
> from the inner sill to the kick panel. More clearly, the measurement from the
> inner sill to the rear most point of the kick panel (where that vertical ,
> removeable panel at the front of the gearbox cover screws on).
> The vertical panel on my friends 100-4 is the correct width, but it falls
> between the driverside kick panel and the passenger side kick panel. We think
> the welder welded the kick panels too far out, like, in the description above,
> too close to your right foot. Am I being clear enough? Ask questions if I'm
> not!
> Thanks (again)
> Paul Barnes
|