gbeaird@io.com wrote:
> Would a M130 be a viable replacement? Can I use the included
> cabling, or the cable that came with our M100 to connect to the GEEZ cube?
> Thanks for any replies.
Gene, I have an M125 which should be the same as the 130, except the 130 has
color (IIRC). I had to buy a separate serial-palm cable at a PDA store to
connect the palm to the cube.
One problem with it I've had, if the 130 has the same connector as the M125,
the connector retention to the Palm is HORRIBLE. I've been searching for a
way to keep the two connected without much luck. The best I've found is an
extra-long and extra strength rubber band wrapping from the connector to the
top of the palm.
Of course I'm doing this on a shifter kart and it's a pain to stuff the palm
into the carrying pouch after setting 'autostart' without disconnecting the
cable. I believe it would be easier if you were putting it into a glovebox or
center console.
Otherwise it has worked with no software problems.
Hope that helps.
Larry MacLeod
Detroit Region - F125
/// Archives at http://www.team.net/archive
/// Check http://www.team.net/mailman/listinfo for other lists of interest.
|