Thanks Byron, I was confused until I put in an old HD and discovered the HW
worked. The new CUBE works GREAT!..
Thanks for the help
Charles Brown
----- Original Message -----
From: "Byron Short" <bshort@AFSinc.com>
To: "Charles Brown" <brow@bright.net>
Cc: <geez@autox.team.net>
Sent: Thursday, April 12, 2001 1:00 PM
Subject: Re: Geez executable error
> I've not seen this error before but the cause you found
> seems correct. The software always looks for a dongle,
> which means searching the parallel ports. If it were to
> fail to find a port, that would be a fatal error, and the
> program would crash. If it does find the port, it then
> tests for the dongle to decide whether to run in full or
> demo mode.
>
> THANKS for finding this, I would have been rather
> flummoxed! But your answer seems right to me!
>
> --Byron
> 888-909-0818
>
> Charles Brown wrote:
> >
> > It seems this error was caused by the network. Even though the
undocked
> > settings enabled the LPT port, after docking, the parallel port was
disabled
> > in the "undocked" config. I am unsure why the error occurred, I guess
the
> > program can't handle unadressable ports at all, even if the dongle isn't
> > required.
> >
> > Regards
> > Charles Brown
> >
> > ----- Original Message -----
> > From: "Charles Brown" <brow@bright.net>
> > To: "Byron Short" <bshort@AFSinc.com>
> > Cc: <geez@autox.team.net>
> > Sent: Thursday, April 12, 2001 10:55 PM
> > Subject: Geez executable error
> >
> > >
> > > I can't get GEEZ.exe to run on my laptop. It does work on all other
> > > machines. The problem is a fatal error at Geez.exe@0015:0F04 Any
Ideas? I
> > > have deleted it as completely as possible, and re-installs of freshly
> > > downloaded software give the same results. I have never used this on
> > *this*
> > > Thinkpad, but one just like it..
> > >
> > > Thanks for any and all Ideas
> > > Charles
///
/// geez@autox.team.net mailing list
///
|