fot
[Top] [All Lists]

[Fot] Oversize alternator pulley source

Subject: [Fot] Oversize alternator pulley source
From: jhasty at mhc-law.com (John Hasty)
Date: Mon, 3 Jul 2017 01:02:58 +0000
References: <CAMJWJcEeiYC6VzPbCsii2AE5NLRBxkVuGGxMr0NcEZQJWpRjVg@mail.gmail.com>, <15d04cb9529-6796-4d87@webprd-m01.mail.aol.com>
Rules say add 25lbs with no alternator

Sent from my iPhone

> On Jul 2, 2017, at 4:05 PM, "Mordy Dunst via Fot" <fot at autox.team.net> 
> wrote:
>
> Why run an alternator?   Do vintage rules require an alternator and a lead 
> acid battery?
>
> Get rid of the alternator and battery and save 30lbs . Get an "antigravity  
> battery".   It weighs 3 lbs, it is safer and has enough power to run the 
> ignition and fuel pump easily for a couple of 25 min sessions.  Get a simple 
> volt meter in the dash . It starts at about 13.4 volts and ends @ 12.9 
> depending on how much you need to crank.  Heck get two -one to power the 
> starter and one smaller for the rest of the car.
>
> That's what I'm told anyways.
>
>
> MDunst Headgasket.com 626.358.1616
> Fax 626.628.3777
> Triple R Munitions, Inc 626.201.9471
> T FFL 6,7 SOT 2
>
> On Sunday, July 2, 2017, John Styduhar via Fot <fot at autox.team.net> wrote:
>
> Bill, could I use my Denso alternator setup to charge the LiPos or what 
> charging system is required??
>
>
> On Sat, Jul 1, 2017 at 1:32 AM, Bill Babcock via Fot <fot at autox.team.net> 
> wrote:
> More realistically:  Typical single cell lipo is 3.7V nominal, 4.3 V fully 
> charged so four cells in series is nominally 14 to 16. Volts, which makes 
> electronic ignition systems much happier than the 12.5 volts of lead acid 
> batteries. A typical little battery for a RC model is 5000mah (or 5AH in more 
> normal parlance) and it's a little smaller than a pound of butter. While one 
> of them might actually crank your motor, five or six is a better bet. I had 
> ten handy that I'm no longer using (new drone) so I put them together for 
> peyote. 50AH, 1000Amps of cranking current. If I ever draw that my starter 
> wire will probably vaporize, but the starter spins briskly. pertronix 
> ignition at 6000 rpm draws five amps. So eight to ten hours of running flat 
> out. That's the biggest load by far unless you're running an electric water 
> pump.
>
> People's bad experience with total loss has to do mostly with lead acid 
> batteries. Electronics are generally designed to run at alternator voltage of 
> 14V. With typical voltage drop an LA battery might drop to 11V at full load. 
> LiPos start with a higher voltage and don't droop as much, so everything 
> works better.
>
> Sent from my iPad
>
> On Jun 30, 2017, at 8:00 AM, D V <explore8 at outlook.com> wrote:
>
> Elon? Is that you? Drove one of your cars the other day....nice.
>
> Sent from my iPhone
>
> On Jun 30, 2017, at 5:30 AM, Bill via Fot <fot at autox.team.net> wrote:
>
> You know, these days I could build a battery that would power any race car 
> for a couple of weeks and weigh fifteen pounds. Why would I bother charging 
> it?? It?s 2017. I made a battery recently that lets me weld aluminum. I can 
> put it in a lunchbox. Alternator, really? Why?
>
>
> On Jun 29, 2017, at 5:00 PM, Bob Totten via Fot <fot at autox.team.net> wrote:
>
> What is the size of the shaft on the Denso ??
>
> Curious,
>
> Bob T
> stom make? Thanks
>> _______________________________________
>
>
>
> -----Original Message-----
> From: Tony Drews via Fot <fot at autox.team.net>
> To: John Styduhar <johnstydo at gmail.com>; Triumph 'Friends of Triumph <fot 
> at autox.team.net>
> Sent: Thu, Jun 29, 2017 3:48 pm
> Subject: Re: [Fot] Oversize alternator pulley source
>
> I'm not sure of the shaft diameter on the Denso
> alternator, but here's a couple of
> possibilities. I think I'm running the first one.
> https://www.summitracing.com/parts/sum-g3969/overview/
> https://www.summitracing.com/parts/pwm-182/overview/
> https://www.summitracing.com/parts/mor-64800/overview/
>
> basically, search for "alternator pulleys" on  www.summitracing.com
>
> Regards, Tony Drews
>
> At 09:20 AM 6/29/2017, John Styduhar via Fot wrote:
>> I'm running a single groove Denso 55A alternator
>> (Lester No. 14684) in my TR racer.? Pulley OD
>> is 2 11/16". Does anyone know where to buy a
>> larger diameter pulley for this unit or will I have to custom make? Thanks
>> _______________________________________________
>> fot at autox.team.net
>>
>> http://www.fot-racing.com
>>
>> Donate: http://www.team.net/donate.html
>> Archive: http://www.team.net/archive
>> Forums: http://www.team.net/forums
>> Unsubscribe/Manage:
>> http://autox.team.net/mailman/options/fot/tony at tonydrews.com
>
>
> _______________________________________________
> fot at autox.team.net
>
> http://www.fot-racing.com
>
> Donate: http://www.team.net/donate.html
> Archive: http://www.team.net/archive
> Forums: http://www.team.net/forums
> Unsubscribe/Manage: http://autox.team.net/mailman/options/fot/robertten1 at 
> aol.com
>
>
> _______________________________________________
> fot at autox.team.net
>
> http://www.fot-racing.com
>
> Donate: http://www.team.net/donate.html
> Archive: http://www.team.net/archive
> Forums: http://www.team.net/forums
> Unsubscribe/Manage: http://autox.team.net/mailman/options/fot/bill at 
> ponostyle.com
>
>
>
> _______________________________________________
> fot at autox.team.net
>
> http://www.fot-racing.com
>
> Donate: http://www.team.net/donate.html
> Archive: http://www.team.net/archive
> Forums: http://www.team.net/forums
> Unsubscribe/Manage: http://autox.team.net/mailman/options/fot/explore8 at 
> outlook.com
>
>
>
> _______________________________________________
> fot at autox.team.net
>
> http://www.fot-racing.com
>
> Donate: http://www.team.net/donate.html
> Archive: http://www.team.net/archive
> Forums: http://www.team.net/forums
> Unsubscribe/Manage: http://autox.team.net/mailman/options/fot/johnstydo at 
> gmail.com
>
>
>
>
> _______________________________________________
> fot at autox.team.net
>
> http://www.fot-racing.com
>
> Donate: http://www.team.net/donate.html
> Archive: http://www.team.net/archive
> Forums: http://www.team.net/forums
> Unsubscribe/Manage: http://autox.team.net/mailman/options/fot/gasket.works at 
> gte.net
>
>
>
> _______________________________________________
> fot at autox.team.net
>
> http://www.fot-racing.com
>
> Donate: http://www.team.net/donate.html
> Archive: http://www.team.net/archive
> Forums: http://www.team.net/forums
> Unsubscribe/Manage: http://autox.team.net/mailman/options/fot/jhasty at 
> mhc-law.com
>
>
CONFIDENTIALITY NOTICE: This electronic mail transmission has been sent by a 
law firm on a legal matter. It may contain information that is confidential, 
privileged, proprietary, or otherwise legally exempt from disclosure. If you 
are not the intended recipient, you are hereby notified that you are not 
authorized to read, print, retain, copy or disseminate this message, any part 
of it, or any attachments. If you have received this message in error, please 
delete this message and any attachments from your system without reading the 
content and notify the sender immediately of the inadvertent transmission. 
There is no intent on the part of the sender to waive any privilege, including 
the attorney-client privilege, that may attach to this communication. Thank you 
for your cooperation. 11 U.S.C. 528(a)(4) NOTICE. We are a debt relief agency. 
We help people file for bankruptcy relief under the federal Bankruptcy Code.

<Prev in Thread] Current Thread [Next in Thread>