Hi Jonathan,
No dumb questions.......
The BN2 transmission is very similar to the 100/6. The bell housing is
different but interchangeable as the 100/6 uses an hydraulic clutch whereas
the BN2 clutch is mechanically operated.
The 1st motion shaft on the 100/6 is longer but can be cut down to allow
use of the transmission in a BN2.
The BN1 transmission, although completely different from a 100/6 could be
replaced by one if a BN2 bell housing and clutch were used and the input
shaft was shortened.
I think that is all of... others may have thoughts.
Michael S
On Wed, Jun 21, 2017 at 12:08 PM, Jonathan Einhorn <
einhornlawoffice at gmail.com> wrote:
> This is dumb but how different are the 100-4 transmissions and 100-6
> transmissions? Both side shift. Are they interchangeable?
>
> Thanks
> jon
>
> --
> Jonathan J. Einhorn, Esq.
> Attorney & Counselor at Law
> 129 Whitney Avenue
> New Haven, CT. 06510
> tel: 203-777-3777 <(203)%20777-3777>
> einhornlawoffice at gmail.com
> fax: 203-782-1721 <(203)%20782-1721>
> cell: 203-623-7373 <(203)%20623-7373>
>
> _______________________________________________
> Support Team.Net http://www.team.net/donate.html
> Suggested annual donation $12.75
> Archive: http://www.team.net/archive
> Forums: http://www.team.net/forums
>
> Healeys at autox.team.net
> http://autox.team.net/mailman/listinfo/healeys
>
> Unsubscribe/Manage: http://autox.team.net/mailman/
> options/healeys/michaelsalter at gmail.com
>
>
>
--
*Nothing is impossible with the correct attitude and a hammer.*
-------------- next part --------------
An HTML attachment was scrubbed...
URL:
<http://autox.team.net/pipermail/healeys/attachments/20170621/3216c9d7/attachment.html>
|