Hello All,
BFE has the STD and .010 in Stock for those interested.
Brian Howlett
British Frame and Engine
626-419-2786
bfeparts at aol.com
-----Original Message-----
From: JIm Gray via Fot <fot at autox.team.net>
To: fot <fot at autox.team.net>
Sent: Tue, Apr 25, 2017 8:28 am
Subject: [Fot] Clevite rod bearings
It looks like Mahle/Clevite are going to discontinue them at least on the
standard bearing size.
Any suggestions on an alternate? I run the Tri-metal mains. I need to get two
sets, one standard and one
.010 under so I can get some measurements. I have a crank that's right on the
edge of running a standard
bearing but I won't know for sure until I can measure the ID's with bearings in
place.
Thanks for the input as always,
Jim Gray
_______________________________________________
fot at autox.team.net
http://www.fot-racing.com
Archive: http://www.team.net/archive
-------------- next part --------------
An HTML attachment was scrubbed...
URL:
<http://autox.team.net/pipermail/fot/attachments/20170425/fc2111a6/attachment.html>
|