It looks like Mahle/Clevite are going to discontinue them at least on the
standard bearing size.
Any suggestions on an alternate? I run the Tri-metal mains. I need to get two
sets, one standard and one
.010 under so I can get some measurements. I have a crank that's right on the
edge of running a standard
bearing but I won't know for sure until I can measure the ID's with bearings in
place.
Thanks for the input as always,
Jim Gray
-------------- next part --------------
An HTML attachment was scrubbed...
URL:
<http://autox.team.net/pipermail/fot/attachments/20170425/2ccf19c4/attachment.html>
|