The oils seeps through the taper.
When I opened the packet with the connectors there were no o-rings supplied.
Is this an extra order?
Chris
-----Urspr|ngliche Nachricht-----
Von: Jim Gray [mailto:toodamnfunky@comcast.net]
Gesendet: Mittwoch, 31. Dezember 2014 15:25
An: 'MadMarx'; fot@autox.team.net
Betreff: RE: [Fot] Aluminum connectors
Chris,
Some fittings are made to use a rubber o-ring. My sandwich plate AN fittings
will leak without the o-rings, Is it the flared side that leaks or is it the
non-flared side ?
jim g
-----Original Message-----
From: Fot [mailto:fot-bounces@autox.team.net] On Behalf Of MadMarx
Sent: Wednesday, December 31, 2014 4:45 AM
To: fot@autox.team.net
Subject: [Fot] Aluminum connectors
Hi @ all,
hope you are getting well to the next year.
My car has many oil lines and also a lot of aluminum connectors and some of
the them do leak.
Is there any trick to seal them?
I think that I have tighten them enough and hesitate to tighten more not to
destroy them.
Is there a seal missing in those connectors?
http://ecx.images-amazon.com/images/I/41P918-F13L.jpg
Just an example what I mean for the system.
Cheers
Chris
_______________________________________________
fot@autox.team.net
http://www.fot-racing.com
Archive: http://www.team.net/archive
http://autox.team.net/mailman/options/fot/toodamnfunky@comcast.net
_______________________________________________
fot@autox.team.net
http://www.fot-racing.com
Archive: http://www.team.net/archive
|
