On Wed, Jun 23, 2010 at 6:53 PM, <tylerpthompson@yahoo.com> wrote:
> Hi Tony and Mike-
>
> I have the same problem. Unfortunately, the current float bowl tops and 3
> screw configuration doesn't give me this option. All I can do is turn them
> 180 degrees. No space for fuel line if I place the pivot front or rear.
>
> Are there options or different tops for the bowls that can help solve this
> problem that folks are aware of?
>
It took me a while to remember this, as I did this so many years ago, but I
bought alternate HS6 float bowl covers from Joe Curto. From another,
non-TRiumph car, these covers had 2 tubes each, one for the fuel inlet, and
the other for the vent (replacing the hole and sheet metal cover vent
arrangement that were on my HS6's). Once aligned as Tony and others have
described, I had no more stumble out of the corners. An additional benefit
was that having a tube on the vents made it easy for me to run vent hoses
down and away from the engine bay.
http://www.joecurto.com/
NFI.
Irv Korey
_______________________________________________
fot@autox.team.net
http://www.fot-racing.com
Donate: http://www.team.net/donate.html
Archive: http://www.team.net/archive
Forums: http://www.team.net/forums
|