I back the bolts out of the rod cap partway and smack the head of the
bolt with a rubber mallet.
- Tony Drews
At 09:12 PM 8/16/2009, Robert Blake wrote:
>Unwashed shade tree mechanic in need of advise. Am attempting to replace the
>rod bearings on my TR4 with minimal success. After loosening the nuts I
>attempted to push the piston up off the crank using the wooden handle of a
>mallet placed against the meaty part of the piston where the wrist pin sets.
>No movement. Yes, I actually did pull the plugs first! I was reluctant to
>beat it too hard. Checked the archives for previous posts on this issue but
>found none. Appreciate any suggestions.
>
>Bob Blake
_______________________________________________
Support Team.Net http://www.team.net/donate.html
http://www.fot-racing.com
Fot mailing list
Fot@autox.team.net
http://autox.team.net/mailman/listinfo/fot
|