Unwashed shade tree mechanic in need of advise. Am attempting to replace the
rod bearings on my TR4 with minimal success. After loosening the nuts I
attempted to push the piston up off the crank using the wooden handle of a
mallet placed against the meaty part of the piston where the wrist pin sets.
No movement. Yes, I actually did pull the plugs first! I was reluctant to
beat it too hard. Checked the archives for previous posts on this issue but
found none. Appreciate any suggestions.
Bob Blake
_______________________________________________
Support Team.Net http://www.team.net/donate.html
http://www.fot-racing.com
Fot mailing list
Fot@autox.team.net
http://autox.team.net/mailman/listinfo/fot
|