I've repaird my block with threaded sleeve. Did work well.
I still have this block. Outside diameter was 18mm.
-----Urspr|ngliche Nachricht-----
Von: fot-bounces@autox.team.net [mailto:fot-bounces@autox.team.net] Im
Auftrag von Don Elliott
Gesendet: Montag, 10. August 2009 19:19
An: Friends of Triumph
Betreff: [Fot] Stripped Threads - RHS rear corner of block
A good friend here in Montreal is re-building the engine for his TR3A
(used for touring) and found that the threads in the top of the block where
the rear RHS head stud is supposed to secure the head has been stripped of
its threads.
He would like to know what is the best option to solving this problem.
He is concerned that a heli-coil may not take the torque. Also a larger
stepped stud, specially manufactured means a larger threaded hole in the
block (like the heli-coil as well) and he is concerned that he may hit a
water passage with both of these options.
Any proven suggestions ?
Fot mailing list
Fot@autox.team.net
http://autox.team.net/mailman/listinfo/fot
_______________________________________________
Support Team.Net http://www.team.net/donate.html
http://www.fot-racing.com
Fot mailing list
Fot@autox.team.net
http://autox.team.net/mailman/listinfo/fot
|