With the amount of squish area and the high compression used in our racing
engines I don't think that more turbulence is required for better
combustion.
----- Original Message -----
From: "Tony Drews" <tony@tonydrews.com>
To: <fot@autox.team.net>
Sent: Saturday, February 28, 2009 2:17 PM
Subject: Re: [Fot] Porting and Polishing (and engine building tips in
general)
> Actually it was "turbulence" they were after, not "swirl".
>
> - Tony
>
> At 04:10 PM 2/28/2009, Tony Drews wrote:
>>One of the circle track motor building articles I read showed the top of a
>>piston that had been dimpled (looked like with a center punch). The idea,
>>as I recall it, was to promote more "swirl" in the combustion chamber.
>>
>>- Tony
>>
>>At 02:10 PM 2/28/2009, Terry Stetler wrote:
>>>Perhaps the term "port shaping" would better describe what is necessary?
>>>
>>>Also, it would seem that if you could put a uniform surface texture along
>>>the
>>>entire port, that would guarantee laminar flow, much as the dimples on a
>>>golf
>>>ball do, that would be the way to go. But now we are getting into the
>>>black
>>>arts, and gray areas of the GCR, etc...
>>>
>>>Terry Stetler
>>>_______________________________________________
>>>Support Team.Net http://www.team.net/donate.html
>>>
>>>http://www.fot-racing.com
>>>
>>>Fot mailing list
>>>Fot@autox.team.net
>>>http://autox.team.net/mailman/listinfo/fot
>>_______________________________________________
>>Support Team.Net http://www.team.net/donate.html
>>
>>http://www.fot-racing.com
>>
>>Fot mailing list
>>Fot@autox.team.net
>>http://autox.team.net/mailman/listinfo/fot
> _______________________________________________
> Support Team.Net http://www.team.net/donate.html
>
> http://www.fot-racing.com
>
> Fot mailing list
> Fot@autox.team.net
> http://autox.team.net/mailman/listinfo/fot
_______________________________________________
Support Team.Net http://www.team.net/donate.html
http://www.fot-racing.com
Fot mailing list
Fot@autox.team.net
http://autox.team.net/mailman/listinfo/fot
|