I don't think so. you can pull the center main with the engine in
place, but I've never figured out a way to pull the seal or the rear
main without pulling the engine.
On Nov 10, 2008, at 5:10 PM, J.C. Hassall wrote:
> I need to change the main bearings in my TR4. The engine is in the
> car with the gearbox attached. Is it possible to pull the rear main
> cap? I'm specifically concerned about the seal - I have the new
> split-type seal. I took lots of pix of the engine as I assembled it
> *except* the split seal and associated bits.
>
> TIA
>
> jim
>
> --
> J.C. Hassall
> Blacksburg VA
> '63 TR4 in autox preparation
> 96% finished, 90% to go
> _______________________________________________
> Support Team.Net http://www.team.net/donate.html
>
> http://www.fot-racing.com
>
> Fot mailing list
> Fot@autox.team.net
> http://autox.team.net/mailman/listinfo/fot
>
Bill Babcock
Babcock & Jenkins
Billb@bnj.com
503.936.7660
www.bnj.com
Editor
Ke Nalu e-Magazine
Paddlesurfing's Web Journal
Bill@kenalu.com
www.kenalu.com
blog: www.ponohouse.com/ponoblog
_______________________________________________
Support Team.Net http://www.team.net/donate.html
http://www.fot-racing.com
Fot mailing list
Fot@autox.team.net
http://autox.team.net/mailman/listinfo/fot
|