Trying to find a solution to this problem, I recently purchased a
quantity of lifters from each of the major suppliers -- BPNW, Moss,
and TRF. I had eight tappets from each supplier checked for hardness.
I found that none of these suppliers furnish tappetts that are
consistently in the middle 50's, Rockwell C scale.
For example, the eight I had checked from one supplier measured 45,
48, 49, 51, 51, 52, 53, 53. The lowest reading I got on all of the
lifters tested was 30.
In addition, some of us are going to a cam that requires a full
diameter stock lifter. Of the three above suppliers, none of them had
the full diameter face -- all had a chamfer around the contact end of
the lifter that reduced its contact face diameter.
I checked with one heat treat company and they told me that chilled
cast iron cannot be successfully nitrided so it sounds like that is
not a possibility.
At 11:58 AM 3/15/2008, Bill Babcock wrote:
>Larry, a crown isn't proper. They call these flat lifters for a
>reason--they need to be dead flat. The cam is designed to work with a
>flat lifter. A crown will reduce the contact area and probably make
>the lifter stop rotating. A pretty sure way to toast your lifters and
>cam.
>
>second, reconditioning lifters is pretty iffy anyway. These things
>need to be as hard as they can be. Grinding them without some
>hardening process involving vile chemicals known by the state of
>california to cause instant death and an alchemist is scary. What you
>need--what we all need, is some very hard lightened lifters with very
>flat non-chamfered, non-crowned faces.
>On Mar 15, 2008, at 8:15 AM, Larry Young wrote:
>
> > Can someone recommend a shop that reconditions lifters, i.e. resurface
> > the foot of the lifter with the proper crown? I've seen a few
> > places on
> > the web, but some seem rather expensive, e.g. Integral Cams $11.70
> > each,
> > Web Cams $5.00 each.
> > Larry Young
> > _______________________________________________
> > http://www.team.net/donate.html
> >
> > Fot mailing list
> > Fot@autox.team.net
> > http://autox.team.net/mailman/listinfo/fot
> >
> > You are subscribed as billb@bnj.com
>
>Bill Babcock
>Babcock & Jenkins
>Billb@bnj.com
>503.936.7660
>www.bnj.com
>_______________________________________________
>http://www.team.net/donate.html
>
>Fot mailing list
>Fot@autox.team.net
>http://autox.team.net/mailman/listinfo/fot
>
>You are subscribed as vinttr4@geneseo.net
_______________________________________________
http://www.team.net/donate.html
Fot mailing list
Fot@autox.team.net
http://autox.team.net/mailman/listinfo/fot
|