Allen is it from all the carbs or just one? If you are running brass floats
check them for holes. The modern additives eat the solder and sink the
floats. Immerse them in hot water and watch for bubbles to check for leaks.
If all the carbs, then definitely replace the regulator...
> On a pre season start up check for gas leaks I am finding a fair
> amount of
> raw fuel from the pump jet dripping into the throat. Will to much fuel
> pressure cause this? The pump jet washer does not look great and seems
> to be
> made of aluminum. The washers all look to be in the same condition.
> Does the
> pump jet cover push down on the pump jet and seat it into the carb.
> body?
> Needle and seat are 2 years old and everything was running fine 8
> months ago.
> I believe the float adj. is correct but has not been checked today
> The fuel pressure has not been changed sense last season but the
> gauge is
> busted and I am on my way out to get a replacement. Could the fuel psi
> regulator given up? It was last adjusted for 3lbs .Any suggestions
> would be
> great thanks rob
> _______________________________________________
> http://www.team.net/donate.html
>
> Fot mailing list
> Fot@autox.team.net
> http://autox.team.net/mailman/listinfo/fot
>
> You are subscribed as awashatko@wi.rr.com
>
>
Jody & Allen Washatko
N65 W5567 Columbia Road
Cedarburg, WI. 53012
USA
tel. (262) 375-6888
**************It's Tax Time! Get tips, forms, and advice on AOL Money &
Finance. (http://money.aol.com/tax?NCID=aolprf00030000000001)
_______________________________________________
http://www.team.net/donate.html
Fot mailing list
Fot@autox.team.net
http://autox.team.net/mailman/listinfo/fot
|