[Fot] checking bearing clearances

["Scott Janzen" <S.Janzen@comcast.net>]

One builder I know installs the bearings in the rod ends or mains, torques the
caps and uses an inside micrometer to check bearing clearances before
installing the rods or crank.
Another one swears that method is not sufficient and you have to use
plastigauge.
What says the group?
_______________________________________________
http://www.team.net/donate.html

Fot mailing list
Fot@autox.team.net
http://autox.team.net/mailman/listinfo/fot