fot
[Top] [All Lists]

Re: [Fot] Spitfire mixture needles

To: "Friends of Triumph" <fot@autox.team.net>, "Greg Solow"
Subject: Re: [Fot] Spitfire mixture needles
From: "KEVIN LYNCH" <klynch_6@msn.com>
Date: Wed, 31 Oct 2007 09:33:48 -0600
Greg, hopefully everything remained on the shelves after the quake from the
Calaveras Fault last nite. Was in S Cruz during the 89' Loma Prieta.
Happy Halloween

Kevin
  ----- Original Message -----
  From: Greg Solow<mailto:gregmogdoc@surfnetusa.com>
  To: Friends of Triumph<mailto:fot@autox.team.net>
  Sent: Tuesday, October 30, 2007 9:12 PM
  Subject: [Fot] Spitfire mixture needles


  We have been working on a 1968 Spitfire Mk 3, It is a stock, very origiinal
  car. We have just done a valve job, installed hard exhaust seat and new
  guides, & replaced the rings. The compression is great and the engine is
nice
  and tight. It has the stock tubular headers that cam on this year car and
the
  dual 1 1/4" HS-2 carbs.
      We are having a tuning problem. With 2 psi fuel pressre at the carb at
WOT
  the engine runs lean, especially at part throttle. The stock spec. calls
for
  "DD" mixture needles. They are way lean. Just bringing the revs up from
idle
  to about 2500 to 3000 rpm with no load the engine spits and runs very
rough.
  Adding fuel makes the engine "rev" right up. We have tried progressively
  richer needles going from the "DD" to "AN", then to "H-6" and finally to
"DK"
  needles. With the "DK" needles installed the engine runs"GREAT' under any
  circumstances
  but I am afraid that it is to rich. I took it on a 35 miles or so road test
on
  Sunday with these needles installed and it was a pleasure to drive! but
seemed
  to just "suck" gas, but this is a subjective judgement as I was not able to
  measure the fuel economy. Note, the cam, displacement, etc. are all stock
in
  this car. I am at a loss to understand why the needles need to be so much
  richer than the stock spec to make this car run properly!
      Does anyone have any ideas or experience with this exact model?

                         Greg Solow
  _______________________________________________
  http://www.team.net/donate.html<http://www.team.net/donate.html>

  klynch_6@msn.com<mailto:klynch_6@msn.com>
  Fot mailing list
  Fot@autox.team.net<mailto:Fot@autox.team.net>
  http://autox.team.net/mailman/listinfo/fot<http://autox.team.net/mailman/li
stinfo/fot>
_______________________________________________
http://www.team.net/donate.html

Fot mailing list
Fot@autox.team.net
http://autox.team.net/mailman/listinfo/fot

<Prev in Thread] Current Thread [Next in Thread>