I have been getting correspondence from Drayton Sleeves. They appear to be a
very serious producer of sleeves, including custom sleeves.
Anyone have any experience with them?
Joe (A)
> Had an email comunication with Ken late last week to see if he had 92's and
> his response was that he did not due to difficulties with machining, etc.
>
> Bill Babcock <BillB@bnj.com> wrote: Yup, Ken gillanders has nice flat top
> wisecos and sleeves from LA Sleeve. I'm
> going to use the 92mm in my street TR3.
>
> -----Original Message-----
> From: fot-bounces+billb=bnj.com@autox.team.net on behalf of Mark J. Bradakis
> Sent: Tue 8/28/2007 9:00 PM
> To: FOT@autox.team.net
> Subject: [Fot] TR3 bore sizes?
>
> So this local club member brings in his TR6 for some work (stuck
> Grose Jet in rear carb) and we start talking about his TR3 project.
>
> Can 89 mm piston sets be had that will make a reliable, streetable
> motor?
>
> mjb.
> billb@bnj.com
> Fot mailing list
> Fot@autox.team.net
> http://autox.team.net/mailman/listinfo/fot
> adcronin@ameritech.net
> Fot mailing list
> Fot@autox.team.net
> http://autox.team.net/mailman/listinfo/fot
>
>
>
> Planning & Development Services
> A. Daniel Cronin
> 248 761-2673
> _______________________________________________
>
</HTML>
_______________________________________________
http://www.team.net/donate.html
Fot mailing list
Fot@autox.team.net
http://autox.team.net/mailman/listinfo/fot
|