Had an email comunication with Ken late last week to see if he had 92's and his
response was that he did not due to difficulties with machining, etc.
Bill Babcock <BillB@bnj.com> wrote: Yup, Ken gillanders has nice flat top
wisecos and sleeves from LA Sleeve. I'm
going to use the 92mm in my street TR3.
-----Original Message-----
From: fot-bounces+billb=bnj.com@autox.team.net on behalf of Mark J. Bradakis
Sent: Tue 8/28/2007 9:00 PM
To: FOT@autox.team.net
Subject: [Fot] TR3 bore sizes?
So this local club member brings in his TR6 for some work (stuck
Grose Jet in rear carb) and we start talking about his TR3 project.
Can 89 mm piston sets be had that will make a reliable, streetable
motor?
mjb.
billb@bnj.com
Fot mailing list
Fot@autox.team.net
http://autox.team.net/mailman/listinfo/fot
adcronin@ameritech.net
Fot mailing list
Fot@autox.team.net
http://autox.team.net/mailman/listinfo/fot
Planning & Development Services
A. Daniel Cronin
248 761-2673
_______________________________________________
http://www.team.net/donate.html
Fot mailing list
Fot@autox.team.net
http://autox.team.net/mailman/listinfo/fot
|