> I've just installed a Denso Alternator in my racing TR6. It
> has 4 wires
> : A stud for B - battery; a three wire pigtail for : IG -
> ignition, L
> - lamp, and P - for ?
> Does anyone have a diagram or know what goes where?
There are lots of different setups available ... in many cases it can be
changed just by swapping out the electronic module inside the alternator.
So it would probably be best to contact the people who sold you the
alternator, and get the information from them as to what module is installed
and how it should be wired.
But most commonly (AFAIK), "P" is an AC output from the alternator that the
ECU can use to determine alternator RPM. If so, you should be able to
safely leave it disconnected.
Randall
(Tedious but unavoidable disclaimer follows)
CONFIDENTIALITY. This electronic mail and any files transmitted with it may
contain information proprietary to NavCom Technology, Inc., or one of its
affiliates, and are intended solely for the use of the individual or entity to
whom they are addressed, shall be maintained in confidence and not disclosed to
third parties without the written consent of the sender. If you are not the
intended recipient or the person responsible for delivering the electronic mail
to the intended recipient, be advised that you have received this electronic
mail in error and that any use, dissemination, forwarding, printing, or copying
of this electronic mail is strictly prohibited. If you have received this
electronic mail in error, please immediately notify the sender by return mail.
_______________________________________________
Fot mailing list
Fot@autox.team.net
http://autox.team.net/mailman/listinfo/fot
|