I have a pressure sparyer bought from my local ACE hardware for $15 (get the
smallest available)that I grafted a Girling master cylinder cap to the hose.
Fill the pressure tank with a can of your favorite fluid. Remove the cap
from car. Screw the pressure tank cap in place. Pump it up to a few pounds
of pressure. Start at the farthest bleeder crack it open until the air
bubbles stop. Tighten it up and go on to the next. I do the whole process in
15 minutes or less.
----- Original Message -----
From: "Chris Kantarjiev" <cak@dimebank.com>
To: <fot@autox.team.net>
Sent: Sunday, December 24, 2006 2:54 PM
Subject: [Fot] speedbleeders? thumbs up or down?
>I see lots of testimonials for these things. They seem like a great
> idea. But I don't know anyone who uses them.
>
> I'm doing calipers on a couple of cars, so now is the time if
> I'm going to install them. Anyone here have good or bad to say?
>
> Thanks.
> _______________________________________________
> Fot mailing list
> Fot@autox.team.net
> http://autox.team.net/mailman/listinfo/fot
_______________________________________________
Fot mailing list
Fot@autox.team.net
http://autox.team.net/mailman/listinfo/fot
|