In a message dated 4/25/04 1:14:34 PM Pacific Daylight Time,
tony@tonydrews.com writes:
<< Revington sells a kit for the TR-2 to 4. It uses a TR-4 pedal
assembly. It's direct bolt in for TR-4, requires a bit of firewall
massaging for TR-3 (not sure how much). >>
I installed this system on my TR-3 when SCCA required a dual system (the same
year that Hardy and Jack Wheeler retired their Triumphs). Two brake master
cylinders and a clutch master cylinder are supplied. A little larger hole
needs to be cut in the firewall, but it uses the existing pedal assemble, which
does not have to be removed.
I gained some finger mussels back then from bending copper tubing in the
engine compartment. I also left the brake light switch connected to the front
brake circuit. You have to get use to shoving harder on the brake pedal to
slow
down or stop.
|