Bob,
I borrowed the correct puller and it was almost easy. I installed one
bearing wrong and had to pull one out to get to it. With a good tool (I used
a Snap-on), even on my very first set of cam bearings, I was able to install
and remove several without damaging them.
Jack
> Has anyone come up with an easy way to pull out incorrectly installed camshaft
> bearings for re-use. I trusted this to my machine shop, and even though they
> have done it before correctly, they got them in all wrong this time.
> Bob Kramer
> rkramer3@austin.rr.com
|