I don't think most welders would recommend fluxcore wire for body panels.
It makes a messy weld that's hard to clean up. At least that's my
experience, but then I'm a fairly lousy welder that tends to default to
gas anyway.
Unless you mave a MIG that can't take a gas bottle (sounds like an
oxymoron, but I saw one)I'd bite the bullet and use argon.
-----Original Message-----
From: Robert Dardano
To: team
Sent: 3/8/2003 4:35 PM
Subject: Gas No gas MIG
Can anyone sujest the proper fluxcore wire to use for Tr-6 body
pannels?My
welder will take .023 up to .035 The rolls are not cheap so I would
like to
start with the right one for the job I have no experiance with welding
but
its something I have wanted to learn. The 2lb starter roll was .035 and
if I
have learned anything it seems I should be useing a lighter gauge.
thanks in advance rob
|