fot
[Top] [All Lists]

Re: TR6 Sway Bar on TR4

To: <N197TR4@cs.com>, <BillB@bnj.com>, <cartravel@pobox.com>
Subject: Re: TR6 Sway Bar on TR4
From: "Gerald Van Vlack" <jerryvv@att.net>
Date: Mon, 27 Jan 2003 18:35:53 -0500
Joe, I did just this on a 4A using a TR 6 Radiator guard. It's a bolt on at
that point. The needed clue is how easy it would be to install a TR 6 Rad
Guard on a 4 frame. It may also be a bolt on but I doubt it. I am certain that
it can be done with a little old Midwest Engineering.
JVV
  ----- Original Message -----
  From: N197TR4@cs.com
  To: BillB@bnj.com ; cartravel@pobox.com
  Cc: fot@autox.team.net
  Sent: Monday, January 27, 2003 3:22 PM
  Subject: TR6 Sway Bar on TR4


  Does anyone have any experience with putting a TR6 sway bar on a TR4.   I
  know there is one out there that is .900 in diameter and it looks like front
  mounting brackets is the only additional fabrication required.

  I looked at Jim Hill's installation and it appears to make sense and an
  improvement over the "stock" Addco. Larger diameter and wider pick up points
  on the A arms.

  Comments?

  Joe Alexander

<Prev in Thread] Current Thread [Next in Thread>