Just for information, you can make your own anti-roll bars very easily by
using "stressproof"
steel. It is almost as cheap as mild steel and easy to work. Heat with a
torch and bend away as you need. I would not use it over 1" thick, just
redesign and shorten the length of the lever arms to compensate. It is also
easy to weld tabs on and drill several holes so that you have an adjustable
bar.
----- Original Message -----
From: R. John Lye <rjl6n@cstone.net>
To: <WEmery7451@aol.com>; <jaboruch@netzero.net>; <FOT@autox.team.net>
Sent: Tuesday, October 31, 2000 5:51 PM
Subject: Re: TR4 #197...Looking for rev limiter & front anti-swaybar
> At 08:34 AM 10/31/00 -0500, WEmery7451@aol.com wrote:
> >Joe,
> >
> >Speedway Engineering in California cut me a 1-1/4" hollow steel bar
> >to my specified length and put splines on the ends.
>
> I am also using Speedway bars front and rear (they are available
> from many of the circle track outfits).
>
> R. John Lye
>
> rjl@gt-classics.com
> http://www.gt-classics.com/
>
>
|