Paul Richardson wrote:
>
> Hi Gang
>
> Since Jack Wheeler asked about the TR4 vibration damper I decided to look
> up when this was fitted in production. Quoting from an original Standard
> Triumph Service sheet ref 2/53 May 1963 from the Allesley Service
> Department the details are as follows:
>
> "A vibration damper was incorporated on TR4 models at approximately
> commission number CT.18000.
>
> The damper, which is attached to the gearbox or overdrive rear extension,
> may also be fitted in service if necessary. It consists of a steel weight
> with a silent bloc type of rubber bush pressed into the centre through
> which a fixing bolt passes. A clip attached to the end of the gearbox
> extension supports the weight and a steady bracket is bolted to the
> existing anti rattle strap (see illustration).
>
> Orders should be placed with the Spares Division and the following part
> numbers apply.
>
> Damper 132604 Nut YN.2910
> Clip 132607 Bolt HB.0811
> Strap 132608 Bolt HU.0806
> Bolt HB.1024 Nut (2) YN.2908
> Washer WN.0069
>
> The fitting of the damper will only reduce vibration between engine speeds
> of 2700 and 3000RPM and any other vibration must be investigated
> independently.
>
> Fitting instructions are shown in the illustration and a Warranty labour
> time of 3.5 hours will be accepted".
>
> Paul
>
>
paul, right you are. list, we have several used damper units . ted
--
Ted Schumacher
TS Imported Automotive
404 Basinger Rd.
Pandora, Ohio, USA 45877
Ph. 800/543-6648 USA/Canada FAX 419/384-3272 24 hour
Ph. 419/384-3022 - tech./general information
Web page http://www.tsimportedautomotive.com
New-Used-Rebuilt-NOS-Performance British car parts.
200 - 300 parts cars in our British-only salvage yard.
|