To: | <TR3197@AOL.COM>, <fot@autox.team.net> |
---|---|
Subject: | Re: Hardware Question-Flywheel attachment |
From: | "Greg Solow" <gregmogdoc@surfnetusa.com> |
Date: | Sun, 10 Oct 1999 10:35:18 -0700 |
It is 3/8 x 24 and it always was this size. The quality of the OE fasteners did change. The later bolts were higher strength. Regards, Greg Solow ----- Original Message ----- From: <TR3197@AOL.COM> To: <fot@autox.team.net> Sent: Sunday, October 10, 1999 7:58 AM Subject: Hardware Question-Flywheel attachment > FOT, > > I remember from past experience that there were two fastener sizes for the > TR3-TR4A flywheels. > > What is the flywheel fastener size in a TR4A and when did the fastener size > change? > > Hoping it is 3/8-24. > > Joe > > > > > |
<Prev in Thread] | Current Thread | [Next in Thread> |
---|---|---|
|
Previous by Date: | Achieving Full FOT Status, Henry Frye |
---|---|
Next by Date: | Re: Hardware Question-Flywheel attachment, TRBILBO |
Previous by Thread: | Hardware Question-Flywheel attachment, TR3197 |
Next by Thread: | Re: Hardware Question-Flywheel attachment, TRBILBO |
Indexes: | [Date] [Thread] [Top] [All Lists] |