datsun-roadsters
[Top] [All Lists]

Re: [Roadsters] Brake lights and Right directional

To: datsun-roadsters@autox.team.net
Subject: Re: [Roadsters] Brake lights and Right directional
From: Paul Bauman <plhbauman@earthlink.net>
Date: Sat, 28 Jun 2014 19:24:11 -0700
Delivered-to: mharc@autox.team.net
Delivered-to: datsun-roadsters@autox.team.net
Domainkey-signature: a=rsa-sha1; q=dns; c=nofws; s=dk20050327; d=earthlink.net; b=Sir7SWzgJW4FhswcvSL8HXzpi6OPe51A8GjA8iECZUCKn5hTB2DaiXhPd7KpXMAU; h=Received:Message-ID:Date:From:User-Agent:MIME-Version:To:Subject:References:In-Reply-To:Content-Type:Content-Transfer-Encoding:X-ELNK-Trace:X-Originating-IP;
References: <000001cf8fbb$d39509d0$7abf1d70$@scotialockup.com> <010301cf9325$d3c26840$7b4738c0$@net>
User-agent: Mozilla/5.0 (X11; Linux i686; rv:24.0) Gecko/20100101 Thunderbird/24.6.0
I'm with Gordon on this one. Ground the daylights out of the car. I have 
ground straps going from the battery to the engine block, and from the 
battery to the starter. I have had accelerator cables spot welded 
internally by having the starter use it for a return to ground. 
Roadsters can't be too cool, too fast or too grounded.

Paul Bauman
67 1600
Westminster, CA



On 06/28/2014 04:08 PM, Gordon Glasgow wrote:
> I did the same thing years ago - failed to hook up the big ground to the
> frame. It wound up frying the voltage regulator (twice) before I figured it
> out. It also melted the housing on the throttle cable because it tried to
> ground through that, too.
>
> Gordon Glasgow
>
> -----Original Message-----
> From: Datsun-roadsters [mailto:datsun-roadsters-bounces@autox.team.net] On
> Behalf Of Gene at Scotia Lockup
> Sent: Tuesday, June 24, 2014 7:52 AM
> To: datsun-roadsters@autox.team.net
> Subject: [Roadsters] Brake lights and Right directional
>
> Thanks for all the suggestions,
>
> I think I needed to be more specific so here goes:
>
> My car is an early 1969 2000 (SRL311-07183), with a single row of fuses.
>
> All the lights were working properly before I removed the engine and
> transmission.
>
> After I reinstalled the motor and trans I didn't tighten the ground from the
> frame to the starter and found that caused the hard starting problem, it was
> acting as if the battery was almost dead. It acts as if something shorted
> out but there are no blown fuses and if the ground was bad it couldn't have
> shorted. I do need to add the reverse lights are not working as well so I
> will be testing that switch as well.
>
> I hope this additional info helps.
>
> Thanks again
>
>   
>
> Gene
________________________________________

datsun-roadsters@autox.team.net

Archive: http://www.team.net/archive
Unsubscribe: 
http://autox.team.net/mailman/options/datsun-roadsters/mharc@autox.team.net


<Prev in Thread] Current Thread [Next in Thread>