It's prettier! g
> Subject: Re: [Roadsters] Header/starter fit issue
>
> > My '68 Roadster project continues to crawl...
> > It came with a stock exhaust manifold and a nice looking header,
> > so I went the route of the header, or course.
>
> I've got to ask, why "of course"? Past posts have discussed factory
> manifold vs aftermarket headers, and my recollection is that if you
> have the correct factory manifold, in good shape without any cracks,
> you're usually better off using it rather than an aftermarket header.
> Nissan actually did a splendid design job on most of the bits on these
> cars, and reportedly their manifold is a better match than aftermarket
> attempts.
>
> Good manifolds are also rare and expensive, so a good header is
> a good substitute if you don't have a manifold available. (key word
> being good, there's also lots of past discussion on flange width,
> proper washer spacing, etc etc). But it's still a substitute.
>
> As far as heat and the starter, yes that's a concern. And wrapping
> the header can lead to early header failure (traps too much heat).
> Jet-Hot ceramic coatings help a lot, I understand, but I have no
> personal experience. A gear reduction shorty H20 starter is a great
> choice.
>
> My opinions, of course...
>
> -- John
> John F Sandhoff sandhoff@csus.edu Sacramento, CA
> ________________________________________
>
> datsun-roadsters@autox.team.net
>
> Donate: http://www.team.net/donate.html
> Archive: http://www.team.net/archive
> Forums: http://www.team.net/forums
> Unsubscribe:
http://autox.team.net/mailman/options/datsun-roadsters/gordon.e.maness@hotmai
l.com
________________________________________
datsun-roadsters@autox.team.net
Donate: http://www.team.net/donate.html
Archive: http://www.team.net/archive
Forums: http://www.team.net/forums
|